Tippmann 98 Custom Factory Parts

This is the correct cylinder hose for the standard cyclone feed and it fits correctly on to the 20-07 1/16" Banjo fittings. Technical Notes The hoses are cut slightly long.  You can cut them with a razor blade to the exact length you need. ...

  Only available as an assembly.  The Outer Housing and Internal Ported Screw are not available separately. See related parts for orings. For 98 RT and A5 RT Systems: Tippmann Sports says it isn't necessary but many players want to upgrade these...

Factory Tippmann Cyclone Feed Cylinder Spring (02-66)

  #14 Cylinder Plug [98 Custom Cyclone Feed System] TA05064

These are the o-rings for the hammer on a Tippmann 98, Tippmann A5, and BT Combat markers. They will also fit the Valve for the Tippmann Guns.

The Tippmann Velocity Screw. Fits most Tippmann markers. Great to have spares! This product is used in the following guns: 98 Custom Non-ACT, 98 Custom ACT, 98 Custom Response ACT, 98 Custom E-Grip Electronic ACT, 98 Custom Pro ACT, 98 Custom Pro...

Hold the valve in place for the Custom 98 series markers. Part 98-26  

1 and 3/16 inches flared end and 5/8 inch flared end. 8 and 3/8 inches long *Please note that the TA02062 has been replaced by TA02140 Gas Line.

ippmann 98 Replacement Part #98-13 - Bolt Handle

Dowel pin to holds the elbow latch in place.

The Tippmann 98 uses a steel braided gas line hose to transfer the gas from the ASA into the valve. Sometimes over time the braided hose can get frayed and damaged that will result into leaks around that area. Grab this part when you starts to see early...